Teach you the maintenance of the glass reactor

The glass reactor is placed in a closed glass reactor under constant temperature conditions. The glass reactor can be stirred under normal pressure or negative pressure according to the requirements of use, and can be used for reflux and distillation of the reaction solution. It is a modern fine chemical industry. Ideal pilot and production equipment for the synthesis of plants, biopharmaceuticals and new materials.

Glass reactor maintenance matters:

1. Use the glass reactor to read the instructions carefully beforehand. Check the instrument: Check the glass body for damage and whether the interface is consistent.

2. Wipe the interface of the glass reactor with a clean soft cloth and apply a little rotating interface at the interface to make the vacuum grease at the interface uniform.

3. The interface of the glass reactor should not be tightened too tightly. It should be checked regularly to loosen the active, so as to avoid the long-term tight lock and cause the connector to die.

4. Turn on the power switch to make the machine run from slow to fast. When the machine is stopped, stop the machine and turn off the switch.

5, the PTFE switch everywhere can not be tightened too much to avoid damage to the glass. After stopping, loosen the PTFE switches, and the long-term stationary state will deform the PTFE piston.

6. Take the glass ring under the glass reactor and check if there is dirt on the shaft. Wipe it with a soft cloth and apply a little vacuum grease. Reinstall it to keep the shaft and seal ring smooth. Regularly clean the sealing ring. 7. Do not allow water to enter the electrical part. Do not get wet.

8. Glass reactors must use original parts manufactured by the original manufacturer when replacing parts. Any use of other parts will cause fatal damage to the machine.

9. When making any repairs or inspections, the glass reactor must be cut off from the power source and water source.

10. After the glass reactor is used, the oil traces left on the surface of the machine must be cleaned with a soft cloth. The stains and solvent remain and remain clean.

Sapphire Washers

Why choose the sapphire?
1-Thinner and Stronger than Standard Glass Windows
2-Transmits Wavelengths Ranging From UV to Mid-Infrared
3-Features Extreme Surface Hardness and Chemical Resistance

Sapphire Windows are manufactured from single crystal sapphire, making them ideal for demanding applications (such as laser systems) because of their extreme surface hardness, high thermal conductivity, high dielectric constant and resistance to common chemical acids and alkalis. Sapphire is the second hardest crystal next to diamonds and, because of their structural strength, sapphire windows can be made much thinner than other common dielectric windows with improved transmittance. Chemically, sapphire is single crystal aluminum oxide (Al2O3), and is useful in a transmission range from 0.2 - 5.5µm.

Applications:
Sapphire Washers
Sapphire Windows
Sapphire Bearings
Sapphire Rods
Sapphire Tubes
Sapphire Wafer
Dome sapphire
Sapphire insulation Film

Sapphire Ball Lens

Sapphire Washers,Optical Sapphire Washers,Sapphire Optical Washers,Sapphire Glass Optical Windows

ChangChun Worldhawk Optics Co.,Ltd , https://www.worldhawk-optics.com